BPPYH - MILLSET L
- MSDS: BPPYH
- Manufacturer: NATIONAL REFRACTORIES AND MINERALS
- Product Name: MILLSET L
- National Stock Number: 9350-00N031973
Product Identification
Product ID:MILLSET L
MSDS Date:08/25/1986
FSC:9350
NIIN:00N031973
MSDS Number: BPPYH
Responsible Party
OAKLAND, CA 94612
US
Emergency Phone: 415-462-1147
Info Phone: 415-462-1147
Cage: 4H756
Contractor
Telephone: 216-482-3841/415-462-1147
Cage: 4H756
Ingredients
SILICA, CRYSTALLINE - QUARTZ
CAS: 14808-60-7
RTECS: VV7330000
Fraction By Weight: <10%
OSHA PEL SEE TABLE Z3
ACGIH TLV: 0.1 MG/M3 RDUST;9293
SODIUM SILICATE (MFR CAS# 15593-82-5)
CAS: 1344-09-8
Fraction By Weight: <35%
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHAL: LONG TERM EXPOSURE TO
RESPIRABLE SILICA MAY PRODUCE PNEUMOCONIOSIS IN SUSCEPTIBLE
PERSONS. SKIN: REPEATED OR PROLONGED CONTACT MAY CAUSE IRRITATION.
EYES: MAY IRRIATE OR INJURE EYES.
Explanation of Carcinogenicity:SILICA, CRYSTALLINE-QUARTZ: GROUP 2A
(IARC), ANTICIPATED TO BE CARCINOGEN. (NTP)
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:MAY AGGRAVATE PRE-EXISTING
REPSIRATORY CONDITIONS.
First Aid
First Aid:SKIN:WASH W/SOAP & WATER. EYES:IRRIGATE IMMEDIATELY W/PLENTY
OF WATER FOR AT LEAST 15 MINS. OBTAIN MEDICAL ATTENTION IF
NECESSARY. INHAL:REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE
O2/ARTF RESP) (FP N). INGEST:CALL MD IMMEDIATELY .
Fire Fighting
Extinguishing Media:USE MEDIA SUITABLE FOR SURROUDING FIRE CONDITIONS .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NOT APPLICABLE.
Accidental Release
Spill Release Procedures:WE RECOM THAT PURCHASER ESTABLISH A SPILL
PREVENTION, CONTROL & COUNTER MEASURE PLAN. PLAN SHOULD INCL PROC
FOR PROPER STOR AS WELL AS CLEAN-UP OF SPILLS/LEAKS. PROC SHOULD
CONFORM TO SAFE PRACT & PRO VIDE FOR PROPER RECOVERY/DISP.
DEPENDING (SUP DAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:USE AN APPROVED RESPIRATOR IF DUST IS
CREATED DURING HANDLING, INSTALLATION OR TEAROUT. THIS PRODUCT IS A
GRANULAR REFRACTORY MIX.
Other Precautions:TOXIC RISK MAY BE ALTERED BY CHEMICAL OR PHYSICAL
CHANGES CAUSED BY CONDITIONS OF USE.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR ADEQUATE FOR
CONTAMINANT CONCENTRATIONS ENCOUNTERED.
Ventilation:NONE SPECIFIED BY MANUFACTURER.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
SPILL PROC:ON THE QUANTITY SPILLED, NOTIFICATION OF THE NRC MAY BE
REQUIRED IN CASE OF HAZARDOUS SUBSTANCES. (SEE EPA & DOT
REGULATIONS; ALSO VARIOUS STATE & LOCAL REGULATIONS.)
Chemical Properties
HCC:N1
Spec Gravity:1.5-2.5
Solubility in Water:<35%
Appearance and Odor:GREY, GRANULAR, WET; NO ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
NOT APPLICABLE.
Stability Condition to Avoid:NOT APPLICABLE.
Hazardous Decomposition Products:NOT APPLICABLE.
Disposal
Waste Disposal Methods:TEST PRODUCT TO DETERMINE HAZARD STATUS &
DISPOSAL REQUIRMENTS UNDER FEDERAL, STATE & LOCAL LAWS &
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.